How To Clean A700245-gbg1 Dual Flush Valve

For more information on WaterRidge 386082, visit the detail product page on WaterRidge website

Removing the Old Flush Valve:

Shut off the h2o supply located backside the tank.
Remove Tank lid.
Bleed the water inside the tank by holding down the flush valve button in a full open position.
Remove the refill tube of the flush valve overflow tube.
Remove the old flush valve.
- Rotate the affluent valve body in counter clockwise direction to un-clip it from the base, lifting it upwards and off. (unit of measurement holds water inside and ca spill when moved)>
Employ the Phillip commuter to loosen the retaining clip screw establish in the lesser of the base, to release the flush valve base of operations from the tank.
When the base of operations clip is loosened, slide the base of operations and clip frontwards, giving the clip clearance at the dorsum. So that, it can be lifted out of the tank pigsty.
(Don't over loosen the retaining screw as the clip may fall inside the trap way).

Installing the New Flush Valve:

Release the flush valve body from the base of operations by rotating information technology to the release indicate.
Loosen the retaining screw to allow the clip to motion to the stop of the threads giving max clearance infinite for the base installation to the tank pigsty.
Place the base of operations over the tank hole opening, angling the retaining clip down inside the forepart of the tank pigsty opening. And so moving the base forward to assuasive the opposite end of the prune to drop into the tank hole on the back.
Re-heart the base of operations effectually the tank hole opening with overflow tube towards the back of the tank and tighten the retaining screw until base is snug (Upper and lower prune should exist in line for Maximum performance).
Before installing the new flush valve dorsum into the base, beginning remove the blue record property the float.
Check the float cup on the affluent valve to ensure it is located at the third graduation up from the bottom.
Rotate the flush valve body dorsum onto the base, and so that the Yellow flush button it to the left, and the bladder cup is facing the front.
Connect the refill tube to the flush valve overflow tube, ensuring there is no kink in the base.

Installing the New Push in the tank lid:

Remove the existing push past loosening and removing the retaining nut.
On the new push button, ensure the rod length is lxxx mm (3 1/8" in length).
When eighty mm (3 1/8") is set, tighten the thread rod lock basics to the button, holding the rods permanently.
Place the new push button into the tank cover. Make sure that Full Flush Button is on the left side of the tank and aligned over the Xanthous flush valve button Partial flush push button is to the right, and over the BLUE flush valve button.
Plough on the water supply.

Adjusting the Water Height inside tank:

Ensure that the h2o summit inside the tank is aligned on the h2o mark stamped on the back of the tank.
If h2o is BELOW the line, rotate the bladder rod spiral CLOCKWISE, lifting the bladder.
Button the flush button and sentinel where the peak settles. Proceed until the proper water summit is archived.
If the water is ABOVE the line, rotate the float rod screw COUNTER CLOCKWISE, lowering the bladder.
Push the affluent valve button, and sentinel where the h2o height settles. Proceed this until the proper water meridian is archived.